Search results

  1. myjeep3

    Which Axles for my LJ build

    Thought I should post a new thread for this. I have two set of axle and trying to decide which set to keep for my LJ build The 04 LJ came with dana 30/44 ratio 3.73, and I have a set of 30/35 geared at 4.88. Running 35" tires and will like to keep them at 35" if not 37. The 30/35 set...
  2. myjeep3

    97 TJ frame stretch to LJ

    My 04 LJ needs a new frame and I have a 97 TJ frame. Can I stretch it to fit? Something like a TJ-6? Can someone point me to the thread @mrblaine made comments on the TJ-6, I can't find it. will build this with an LS 5.3 engine. Thanks for any and all input.
  3. myjeep3

    Can a TJ VIN be used on TJ Unlimited build?

    Building a TJ Unlimited from sourcing frame and tub separately, and other piece separately, and have a 98 TJ Complete to use for parts. Will use Axles, suspension, trans+Tcase, etc. Can I use the TJ vin on the Unlimited? I will be using the trans from the TJ with a LS motor, so though it would...
  4. myjeep3

    1997 TJ 4.0 to LS 5.3 Gen 3 Swap

    Hello, I am prepping to do an LS Swap in my 97 TJ with manual transmission, and 4.0 engine. I know there are many docs on this, but wanted to go through the list of parts needed. I called Novak and they sent me a list of parts for the build. I am planning on retaining the 5 speed transmission...
  5. myjeep3

    RPM at 2500 while stationed - 97 TJ 4.0 with manual transmission

    I had a dead battery yesterday due to leaving the light on. Got a jump from someone, and as soon as the jeep started, the rpm was at 2500 while the gas pedal nor the clutch was pressed. If I press the clutch, shift and drive, all seem okay until I get to a stop, the rpm will go to 2500. All this...
  6. myjeep3

    Rear crossmember repair

    Can this cross member be saved? I was thinking about welding a 1/8 metal plate on top of whats there for reinforcement. Most of metal on the crossmember is still solid, just the ends need help. Any thoughts, suggestions, tips, warnings, etc?
  7. myjeep3

    Steering feels tight after replacing box

    I replaced my leaking steering box on my 97 Tj. The box i used is from a Jeep zj. Am not sure how the steering suppose to feel like as mine has always been very loose. The steering feels tight. The box i used had a longer pitman arm compare to the original one i had, and I have a 3" suspension...
  8. myjeep3

    Fuel level reading off?

    I replaced the fuel pump because of a starting issue where it would take a long time before starting. Now it starts right up. I had low fuel when i drop the tank, replaced the pump, drove around, thn the low fuel light came on. Stop at a slgas station, added 5 gallons, however the fuel level on...
  9. myjeep3

    Random wire

    I have a 97 TJ, and found this random wire cut up, and a connector, and need help identifying. I have a 4.0 engine with manual tran
  10. myjeep3

    Who has two different seats color/style front and back

    Share images of your front and back seats if they are different. I found some brown rear seat out of a mercury mountaineer, I will install in the back, but having hard time finding matching color for the front. So may have to go with non Wrangler black front seats, or keep my TJ front seats if...
  11. myjeep3

    Speedometer gear for 4.88 ratio

    My 97 TJ speed is about 10 mph off, it reads about 70 mph on dash while the gps is only at 58. I read that i need to replace the speedometer gear, base on some chart I looked at, i need a 38 gears. Is that right? Where to buy the gear I have a 4.88 gear ratio and running tire size of...
  12. myjeep3

    2008 Mountainer rear jump seat in TJ

    Will install these seats in my 97 TJ. Which seat should I go with? Both will fit. Will put a car seat on them for my younger kid. Thanks
  13. myjeep3

    1997 TJ heat turns off randomly while driving

    1997 TJ 5-speed I have a very random issue where the heat would turn off randomly while driving, and I cannot figure out what is causing it to go off. At times it happens while am switching gears, and/or maybe when going over a bump, cant really tell what triggers it to go off, and there is no...
  14. myjeep3

    Traction on front right wheel when in 2H

    I Have a 97 TJ and lately the right side front wheel traction always engages when driving in 2x2 2H. Dry roads feel like am slipping when taking off, and on hard acceleration, the entire truck would shake. when i am in 4H, it feels normal. Any ideas?
  15. myjeep3

    Will 2005 Jeep Commander seats fit in a TJ?

    Found these seats from a 2006 jeep commander for $80 and and to know if they would fit in my TJ. They are powered so wll have to make them move some how. Thanks
  16. myjeep3

    Is this a ground issue on my 97 TJ?

    I have a 97 TJ, and believe i have some ground issues. At times, the Heat would stop working, the speakers would have a static sound, and the radio would go dead, Then I would prep the clutch down and, randomly the heater blower will start up again, and radio would come on. Any idea what it...
  17. myjeep3

    1997 Jeep TJ death wobble

    I am investigating a death wobble issue on my 97 TJ. It started recently, the driver side wheel would shake badly when I drive in a pot hole of uneven road. To stop the shaking/vibrations I must press the brake pedal then it will come back to normal again. This doesn't happen all the time, but...
  18. myjeep3

    Tan color seats, gray interior

    I picked up these seats to replace what I had cause it easier for my kid to jump in the back seat, but now the gray dash and door panels dont match. Thinking about painting the dash and door panles tan color or maybe go with a seat cover. Any suggestions?
  19. myjeep3

    Alignment needed?

    I had a rear bent axle, so I end up replacing both rear and front axles. It was straight forward as I just disconnected one side of the control arms to the axles and dropped both axles. Replacement axles are in. Do I need alignment? An alignment was done before the rear axle bent and no other...
  20. myjeep3

    Rear axle not aligned on one side

    Happy new year all. My 97 TJ was hit on the driver side rear corner, the upper and lower control arms absorbed the impact and did bent. I replace all lower and upper control arms, and all was good, until I noticed that the tire on that side wasnt seating straight. Went to get it aligned, and...