Search results

I have been chasing down a vibration for a long time and have played with new driveshafts, rebalancing tires, new yokes on front and rear axles, and pinion angles. How much runout is acceptable on the sye shaft? My vibration starts around 50mph and up, and is felt in the seat . I took the...

Been researching and trying numerous solutions to solve a vibration I have in the rear end of the jeep, it can be felt in my seat from 50-63 or so mph, after that it either fades out or isn't as noticeable. I have played with pinion angle in the rear anywhere from -2 to +1 and no change, I have...

Im looking at getting a new pair of shocks for the front of my jeep, and started going down the rabbit hole of options. I was looking at a few different options from fox, their performance shocks, their performance with the reservoir, and their factory race 2.0 smooth body shocks (would get...

Selling my bilstein 5100 front shocks, they are listed for a 3.4-4" lift. The actual model number is included in the photos to reference length. The shocks have roughly 5000 miles on them give or take. Looking for $50, prefer local pickup.

Had some tires removed at a local tire shop in Ct, and got them back and two look like this. The question is, is this the fault of the shop for removing them improperly? I have never had a tire look like this after being taken off a rim. Was hoping to swap them over to the rim after re finishing...

Looking to replace my 4.0 and found a clean 93' yj 4.0. assuming I swap all accessories over, is the long block the same?

Looking to replace the 4.0 in my 98', and so far I found a very low mileage 97' 4.0 from an XJ. is this a direct bolt in swap? Do the accessories bolt up (ie alternator)?

I have an issue where one side of the tab that holds the threaded rod in place for the door latch has broken off, allowing the rod to pop out any time you try to open up the door. Looking to see if anyone has a solution before buying a new latch. Photo attached with an arrow of the broken part.