So my 2005 LJ with approximately 150,000 miles on it has been leaking ATF slowly. It’s hasn’t been a huge concern of mine as I’ve just been periodically adding fluid. I constantly check the level to make sure I keep up on it and every time I do, the dipstick reads just fine. However, I’ve had to drain the transmission fluid a couple times now & each time is has been about a quart & a half low (again, even though the dipstick reads that it’s good). Now I have a CEL & one of the codes is p0700. I’ve read that low transmission fluid could be one cause of this code. Before I go out and buy a new TCM, I was curious if anyone had any advice/ideas on how to get a true reading on the dipstick? I’ve checked it while hot, cold, level ground, etc. & again it’s read fine when I know after draining fluid that it is low.